[Bldg-sim] error message in PowerDoe
Leela Kala
kala_sim at yahoo.co.in
Fri Jun 21 15:02:11 PDT 2002
Hi,
I get an error message in PowerDoe
: Pump: DEFAULT-CW-PUMP is not attached to any
equipment.
In the model, there is already a pump assigned to the
CW loop. Everytime I delete this default pump the
simulation runs without error but when I open the
model again this Default-CW-Pump is created by the
program.
Pl let me know how to resolve this problem.
The BDL file creates the following entry:
"CW Loop" = CIRCULATION-LOOP
*7255 * LIBRARY-ENTRY "DEFAULT-CW"
* 1 * $LIBRARY-ENTRY DEFAULT-CW
CIRCULATION-LOOPStarting Points
* 2 * TYPE = CW LOOP-PUMP = DEFAULT-CW-PUMP
..
* 1 * $LIBRARY-ENTRY DEFAULT-CW-PUMP
PUMP Starting Points
* 2 * FLOW-RATIO 1.1 HEAD-RATIO 1.1 ..
*7256 * LOOP-PUMP = "CW PUMP"
Thanks
L. Kala
________________________________________________________________________
Want to sell your car? advertise on Yahoo Autos Classifieds. It's Free!!
visit http://in.autos.yahoo.com
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list