[bldg-sim] Attached buildings in eQUEST
Kevin Madison
kevinjm5000 at yahoo.com
Wed Dec 28 13:00:19 PST 2005
To the list -
There seems to be some discussion about simulating adiabatic walls in
eQUEST. Using the eQUEST Schematic Design or Design Development wizard
this is very easy to do. In the building footprint screen of the wizard,
right click on any exterior wall and you will be able to identify that
wall as entirely adiabatic, partially adiabatic (and what portion) or
entirely exterior. This feature has been available in the general
release of eQUEST for quite some time.
Unfortunately, this and many other useful features are not well
documented due to our funding sources being primarily earmarked for
feature development and enhancements. Recently, however, we have
received significant funding to develop much better documentation for
the eQUEST wizards, detailed interface, reporting modules and life cycle
costing capabilities.
Additionally, the DOE 2 BDL and simulation engine is fully supported by
the eQUEST detailed interface. From within the detailed interface, you
can create INTERIOR-WALLs with INT-WALL-TYPE=ADIABATIC, which means the
NEXT-TO assignment is not required. For more information on
INTERIOR-WALL command, refer to the DOE 2.2 documentat, Volume 2
Dictionary. Complete DOE-2.2 documentation is available from
http://doe2.com/DOE2/index.html. See the bottom of the page.
Regards,
- Kevin Madison
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list