[bldg-sim] Modelling an automatic radiation responsive exterior pull down shade
Jeff Haberl
jeffhaberl at tees.tamus.edu
Sat Oct 29 15:32:19 PDT 2005
Ms Jaya Mukhopadhyay looked at some related issues in her MS thesis at Texas A&M
Jeff
BB 8=! 8=) :=) 8=) ;=) 8=) 8=( 8=) :=') 8=) 8=) 8=? BB
Jeff S. Haberl, Ph.D., P.E.............................jhaberl at esl.tamu.edu
Professor......................................................Office Ph: 979-845-6507
Department of Architecture.......................Lab Ph: 979-845-6065
Energy Systems Laboratory.......................FAX: 979-862-2457
Texas A&M University..............................77843-3581
College Station, Texas, USA.......................URL: www-esl.tamu.edu
BB 8=/ 8=) :=) 8=) ;=) 8=) 8=() 8=) 8=? 8=) 8=) 8= BB
-----Original Message-----
From: bldg-sim at gard.com <bldg-sim at gard.com>
To: bldg-sim at gard.com <bldg-sim at gard.com>
Sent: Fri Oct 28 10:36:04 2005
Subject: [bldg-sim] Modelling an automatic radiation responsive exterior pull down shade
Hello everyone:
I am now encountered a problem in modeling an automatic pull down exterior shades of a window, and am seeking your help. The radiation responsive exterior shade will be triggered when the radiation arrives on the exterior surface of the window pane exceeds a certain amount (say 30btu/ft2hr). Since there is a relatively good insulation properties of the exterior shade (say U-value= 1.1 W/m2h), I would like to let DOE2 to take the insulation effect of the shades when it is deployed into consideration. Do you have any suggestions on how to model this?
Any slight comments will be highly appreciated!
best regards
Kuo-Tsang Huang
PhD. Candidate
National Cheng-Kung University
Architecture Dept.
More information about the Bldg-sim
mailing list