[BLDG-SIM] modeling gas-fired radiant heating

[Renee J. Azerbegi]

This is an email from Linda Morrison of ambient energy.

Using eQuest, ambient energy is modeling a maintenance bay that has
gas-fired radiant heating, gas-fired make-up air units, direct evaporative
cooling and heat wheel heat recovery.  

I plan on using a System Type of Single Zone with furnace (so I can include
an outside air unit), direct evaporative cooling as a preconditioner, and a
heat wheel heat recovery.  

eQuest Help suggests using a gas fired unit heater to simulate the gas-fired
radiant heating but I can't model this because I cannot add outside air.  

Zone type heating options are furnace, gas fired hydronic, hot water loop?

Suggestions?

Best, 

Linda


Linda Morrison, PE, CEM, LEED-AP

ambient energy - solar & sustainable design solutions
linda at ambient-e.com   ambient-e.com
4392 ulysses way,  golden, colorado  80403
direct: 303-860-9634   main: 303-278-1532 fax: 303-278-8533




======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM