[BLDG-SIM] converting Visual DOE to eQuest
Rohini Brahme
rbrahme at harc.edu
Fri Mar 2 06:51:41 PST 2007
There is a document on the doe2.2 site that gives the steps for changing
2.1 inp to 2.2 inp. I had done it once before and it worked - also it
was less time consuming then redoing the whole thing again in 2.2.
- Rohini
-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of
Alec Stevens
Sent: Thursday, March 01, 2007 4:18 PM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] converting Visual DOE to eQuest
Hi,
Sorry if this question may have already been covered in the
past, but I was wondering if there is a straightforward way to convert
Visual DOE files to run in eQuest, or at the least to grab the building
geometry out of the Visual DOE input file and have it translate into
eQuest. A brief look at the Visual DOE input file indicated that it was
based on DOE 2.1E and not 2.2.
Any suggestions are appreciated.
Sincerely,
Alec Stevens, PE, LEED AP
DMI
450 Lexington St., Newton, MA 02466
p: 617-527-1525 x105 f: 617-527-6606
e: astevens at dmiinc.com
==================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20070302/5b563a57/attachment-0002.htm>
More information about the Bldg-sim
mailing list