[Bldg-sim] Sloped Roof using eQuest

Todd Lagus TLagus at Sebesta.com
Thu Mar 27 06:56:09 PDT 2008


Hello,

 

I know that I have to enter the detailed design interface in eQuest to
model a flat, one way sloped roof.  However, when I specify a tilt
angle, the roof plane doesn't rotate around the axis that I want it to
with respect to the outward normal.  It seems like there should be three
different rotation angles - one about each orthogonal axis - to cover
all of the degrees of freedom, but there are only two.  Is there any way
around this?  Any tips would be greatly appreciated.

 

Thanks,

 

Todd

 

Todd Lagus

Mechanical Engineer

Sebesta Blomberg

2381 Rosegate

Roseville, MN 55113

Phone: 651-634-7236

Fax: 651-634-7400

www.sebesta.com <http://www.sebesta.com> 

 

This message has been sent via the Internet. Internet communications are
not secure against interception or modification. Sebesta Blomberg
therefore cannot guarantee that this message has not been modified in
transit. This message and any files transmitted with it are confidential
and intended solely for the use of the addressee. If you have received
this message in error, please notify the sender and destroy your copies
of the message and any attached files.

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20080327/e813b55f/attachment.htm>


More information about the Bldg-sim mailing list