[Bldg-sim] LEED CS EA C1 Optimize Energy Performance calculation

[Gurneet Monga]

Hi Ashu,

Yes, if 25% is the total energy used by the system that are owned,
installed, and/or operated by the developer, 5% of the whole  building
savings will qualify.

Regards

Gurneet Singh
Project Manager
Environmental Design Solutions
657 Sector A, Pocket C, Vasant Kunj-70



On Mon, May 10, 2010 at 1:38 PM, ashu gupta <kce2 at kamalcogentenergy.com>wrote:

>  Dear Folks.
>
>
>
> As we know that the minimum two points are mandatory for projects
> registered after June 26, 2007 which is 14% for new construction type in
> Core & Shell.
>
>
>
> As per my understanding, to achieve minimum two points 14% savings
> vis-a-vis *Whole Building Load* is required but recently there has been a
> change and we found information (attached) and a excel spreadsheet tool
> which shows that to achieve the minimum two point, 14% savings of *Core &
> Shell Building Load* is required and minimum in our case two points can be
> achieved by only 5% savings of *whole building load* if 25% of Energy Cost
> Influenced or Directly Controlled by CS Owner/Developer.
>
>
>
> Thus, can someone please confirm that if we achieved the 5% savings of *Whole
> Building Load* then we qualify as per this new info?
>
>
>
> Any suggestions would be greatly appreciated!
>
>
>
> Regards,
>
>
>
> Ashu Gupta,
> Project Engineer,
> Kamal Cogent Energy,
> Kamal Ratan Chanbers 1st Floor,
> Opp. GPO, M.I. Road,
> Jaipur 302001
> Ph 141 2373185 (W)
> Ph +91-9928049499 (M)
> kce2 at kamalcogentenergy.com
> www.kamalcogentenergy.com
>
>
>
> _______________________________________________
> Bldg-sim mailing list
> http://lists.onebuilding.org/listinfo.cgi/bldg-sim-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> BLDG-SIM-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20100510/d239596d/attachment-0002.htm>