[Bldg-sim] Process Load Density

[Dimitri Contoyannis]

Also, check out COMNET (http://www.comnet.org/mgp-manual).  The MGP manual contains a set of internal gain assumptions for each building type and space category.  The plug loads were derived from CBECS data.  It also contains lighting gain info from 90.1 and Title 24, schedule assumptions (also from ASHRAE and T24), plus occupancy assumptions, and gas process loads.
 
Dimitri

>>> 


From: Rob Hudson <rdh4176 at gmail.com>
To:Ahmed Azhari <a2_azhari at hotmail.com>
CC:<bldg-sim at lists.onebuilding.org>
Date: 10/13/2011 6:56 AM
Subject: Re: [Bldg-sim] Process Load Density
Use the ASHRAE Fundamentals book for internal load calculations for a large list of average values of kitchen and office equipment. 

Also the 90.1 User's manual has a table G-B in the back that has some average densities that usually is a good start, but it is always different for your specific building application and use.

Rob

On Thu, Oct 13, 2011 at 9:51 AM, Ahmed Azhari <a2_azhari at hotmail.com> wrote:



Hi all,Is there some sort of a reference for process load density (W/m2) for each building type and where can I find that? 
Thank you very much for your assistance.


Ahmed 

_______________________________________________
Bldg-sim mailing list
http://lists.onebuilding.org/listinfo.cgi/bldg-sim-onebuilding.org
To unsubscribe from this mailing list send a blank message to BLDG-SIM-UNSUBSCRIBE at ONEBUILDING.ORG





-- 
Rob Hudson
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20111013/2e719148/attachment-0001.htm>