[Bldg-sim] Recommended reading on comparison of models to actual?

Jeff Haberl jhaberl at tamu.edu
Tue Jun 18 13:05:48 PDT 2013


Jeremiah,

I think you'll find a room full of experts and lots of advice on this at the upcoming SPC 209 Meeting at ASHRAE in Denver. I've enclosed a copy of the agenda, as well as the Chair's email, Jason Glazer. Part of the work for 209 is assembling the list you are looking for.

Also, you'll find useful information in the new Guideline 14, and in the Energy Management Handbook, by Doty and Turner. www.ibpsa.org<http://www.ibpsa.org> and the www.esl.tamu.edu<http://www.esl.tamu.edu> are also good places to check as well.

Jeff

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
AGENDA
ASHRAE SPC209 Energy Simulation Aided Design
Monday, June 24, 2013
2:15-6:15p Governor's Square 12 (plaza building, concourse level)
Sheraton Denver Downtown -
Denver Colorado

1.     CALL TO ORDER
1.1. Roll Call/Quorum Determination
1.2. Introduction of Members and Guests
1.3. Announcements
2.     AGENDA REVIEW
3.     MINUTES OF THE LAST MEETING - Nelson
4.     LIAISON REPORTS - Anyone present
5.     SUBCOMMITTEE REPORTS
5.1. Predesign Subcommittee - Sheffer
5.2. Conceptual design/Schematic design - Katzenberger
5.3. Design development/Construction documents - Baker
5.4. Construction/Commissioning/As-Built/Operations - Reddy
5.5. Resources/References/Definitions Subcommittee - DeBaillie
6.     OLD BUSINESS

7.     NEW BUSINESS

8.     NEXT MEETING:
8.1. Standards writing tutorial
8.2. Subcommittee calls
8.3. Full committee calls
9.     ADJOURN

Subcommittee Meeting Times and Locations: (all in plaza building, concourse level)
SPC 209 Predesign Subcommittee - Sunday 6:00-10:00p Plaza Court 3
SPC 209 Design development/Construction documents - Sunday 6:00-10:0p Plaza Court 6
SPC 209 Construction/Commissioning/As-Built/Operations - Sunday 6:00-10:00p Plaza Court 1
SPC 209 Resources/References/Definitions Subcommittee- Monday 8:00a-Noon Plaza Court 1
SPC 209 Conceptual design/Schematic design -Monday 8:00a-Noon Plaza Court 7


++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

8=!  8=)  :=)  8=)  ;=)  8=)  8=(  8=)  8=()  8=)  8=|  8=)  :=')  8=)8=?

Jeff S. Haberl, Ph.D.,P.E., FASHRAE.............. jhaberl at tamu.edu<mailto:jhaberl at tamu.edu>

Professor............................................................Office Ph: 979-845-6507

Department of Architecture.............................Lab Ph:979-845-6065

Energy Systems Laboratory.............................FAX: 979-862-2457

Texas A&M University.....................................77843-3581

College Station, Texas, USA, 77843..................URL:www.esl.tamu.edu

8=/  8=)  :=)  8=)  ;=)  8=)  8=()  8=)  :=)  8=)  8=!  8=)  8=? 8=)8=0

From: bldg-sim-bounces at lists.onebuilding.org [mailto:bldg-sim-bounces at lists.onebuilding.org] On Behalf Of Jeremiah Crossett
Sent: Monday, June 17, 2013 9:09 PM
To: bldg-sim at lists.onebuilding.org; Terry Puccini
Subject: [Bldg-sim] Recommended reading on comparison of models to actual?

Dear bldg sim,

I am looking for papers that elaborate on the concept of modeling, and how it correlates to actual utility data to share with people within my company.

The questions keeps popping up, eg..

  1.  How does a baseline building compare to an average building?
  2.  How does a proposed building typically stack up against the utility bills once the building is built?
  3.  How accurate an existing building model should be to be considered useful, and how accurate is typically possible?
  4.  For an experimental setup what would be considered to be close enough to be considered a "validated" model?
My understanding is that modeling is to show relationships between average a baseline of a chosen vintage and that of a proposed design in terms of relative percentages.  For existing buildings I think that useful is within 20% and typically possible is 10%. Then for a validation model, the most important factor is similar curves and close totals.

If anyone has any recommended papers, or personal experience it would be appreciated.

Kind regards





Jeremiah D. Crossett  | Senior Analyst  |  Phase Change Energy Solutions
120 E. Pritchard St.  | Asheboro, NC 27203  | Mobile 503-688-8951
www.phasechange.com<http://www.phasechange.com>
  [http://i.imgur.com/Sldxf.jpg]



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20130618/7bec1fbb/attachment-0001.htm>


More information about the Bldg-sim mailing list