[Equest-users] eQuest GSHP inputs

Todd Lagus TLagus at Sebesta.com
Tue Jun 17 10:00:49 PDT 2008


Hello All,

 

I can't seem to get my space to cool using my GSHP even when I specify
sufficient cooling in terms of capacity and flow.  This is my first shot
at this type of system, so there are a lot of things that could possibly
be incorrect.  I imported coefficients from a ClimateMaster GSHP for
operating curves, but that still may be an issue.  What should the
temperature inputs be for the ground source heat exchanger loops,
specifically the HW, CHW design temperatures, and the minimum/maximum
reset and alarm temperatures.  I'm trying to model a GSHP system with 45
degree ground source water in heating and 55 degree ground source water
in cooling.  I always end up with a warning about going above the
maximum alarm temperature, and the loop shuts down.

 

Thanks in advance.

 

Todd Lagus, EIT

Mechanical Engineer

Sebesta Blomberg

2381 Rosegate

Roseville, MN 55113

Phone: 651-634-7236

Fax: 651-634-7400

www.sebesta.com <http://www.sebesta.com> 

 

This message has been sent via the Internet. Internet communications are
not secure against interception or modification. Sebesta Blomberg
therefore cannot guarantee that this message has not been modified in
transit. This message and any files transmitted with it are confidential
and intended solely for the use of the addressee. If you have received
this message in error, please notify the sender and destroy your copies
of the message and any attached files.

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20080617/57fa3299/attachment.htm>


More information about the Equest-users mailing list