[Equest-users] Unmet Hours

[Brian Fountain]

Can't wait for version 3.64 which explicitly reports heating and cooling 
hours in the BEPS report. 

Dakota Kelley wrote:
>
> ...the way the hours are counted.  The Air-Side Summary report is good 
> for showing heating vs. cooling hours, and which zones are 
> problematic, but it counts hours simultaneously and yields an inflated 
> number.   Multiply the percentage in the BEPS report by the number of 
> hours the fans are on and you'll have the number you're looking for.  
> To split that total between heating and cooling, I apply the same 
> ratio shown in the Air-Side Summary report.  There's probably a more 
> accurate way to do it, but another user will have to enlighten all of 
> us...
>
>  
>
>  
>
>                                
>
> *DAKOTA KELLEY ***
>
> Project Designer | Energy Analyst
>
>                          
>
>                               Office: 214.744.6199                
>
>                               Cell: 214.280.3825
>
>                               Fax: 214.744.0770   
>
>  
>
> http://www.teliospc.com <http://www.teliospc.com/>         3535 Travis 
> St. Suite 115
>
> dakotak at teliospc.com <mailto:dakotak at teliospc.com>            Dallas, 
> TX 75204                                                    
>
>                                
>
> | MEP ENGINEERING ? ENERGY MODELING ? LEED CONSULTATION ? COMMISSIONING |
>
> * *
>
> CONFIDENTIALITY NOTICE: This email is intended only for the use of the 
> individual or entity to which it is addressed,
>
> And may contain information that is privileged, confidential and 
> exempt from disclosure under applicable law. If you
>
> are not the intended recipient, please email the sender immediately, 
> and delete this email from all computers.  Any
>
> distribution or other use is strictly prohibited.  Copyright © 2009 
> Telios Corporation.
>
>  
>
>  
>
>  
>
>   
>
>  
>
> *From:* Martz, Amanda [mailto:amartz at klingstubbins.com]
> *Sent:* Thursday, July 15, 2010 3:22 PM
> *To:* Kelsey VanTassel; M. Shields; equest-users at lists.onebuilding.org
> *Subject:* Re: [Equest-users] Unmet Hours
>
>  
>
> When I look under the summary tab, it says I have 34% unmet hours. 
> When I look at the BEPS report, it says I have 3%. Does anyone know 
> what the difference in these numbers is?
>
>  
>
> ------------------------------------------------------------------------
>
> *From:* equest-users-bounces at lists.onebuilding.org 
> [mailto:equest-users-bounces at lists.onebuilding.org] *On Behalf Of 
> *Kelsey VanTassel
> *Sent:* Thursday, July 15, 2010 3:50 PM
> *To:* M. Shields; equest-users at lists.onebuilding.org
> *Subject:* Re: [Equest-users] Unmet Hours
>
>  
>
> I like to look under Airside HVAC. Click on the summary tab, then 
> click on "project" in the component tree on the left hand side. It 
> will show you the sum automatically.
>
>  
>
> *Kelsey Van Tassel***
>
> Mechanical Engineer | kvantassel at sustaineng.com 
> <mailto:kvantassel at sustaineng.com>
>
> 608.836.4488 ext. 20 | Fax: 608.836.4477
>
>  
>
> Sustainable Engineering Group
>
> 901 Deming Way, Suite 201
>
> Madison, WI 53717
>
> www.sustaineng.com <http://www.sustaineng.com/>
>
>  
>
>  
>
> *From:* equest-users-bounces at lists.onebuilding.org 
> [mailto:equest-users-bounces at lists.onebuilding.org] *On Behalf Of *M. 
> Shields
> *Sent:* Thursday, July 15, 2010 2:47 PM
> *To:* equest-users at lists.onebuilding.org
> *Subject:* [Equest-users] Unmet Hours
>
>  
>
> Hi All,
>
>  
>
> I am trying to determine the number of unmet cooling and heating hours 
> for my model.  From what I've read on the BEPU/BEPS reports I can find 
> the % of the hours that the load is unmet, but is there a way to break 
> this out into cooling and heating time?  The other alternative I see 
> is to go through either the SS-F reports, or the Air-Side HVAC section 
> and add up all of the zones unmet heating and cooling hours.  Does 
> anyone know of a better way to determine this?
>
>  
>
> Thanks,
>
> Michael Shields
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>   
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 9.0.839 / Virus Database: 271.1.1/3008 - Release Date: 07/15/10 14:35:00
>
>   

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100715/631370a1/attachment-0002.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 2143 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100715/631370a1/attachment-0002.jpeg>