[Equest-users] Individual Process Loads
jra_sac at yahoo.com
Sat May 1 22:46:43 PDT 2010
These individual end uses, if assigned to different zones rather than on a building level, will appear in LS-K (Space Fuels) with their assigned spaces. Then you can identify them.
From: "omoltay at mimtarch.com" <omoltay at mimtarch.com>
To: equest-users at lists.onebuilding.org
Sent: Sat, May 1, 2010 8:02:47 AM
Subject: [Equest-users] Individual Process Loads
Just realized that I may have done a mistake now. All of my process loads
(computers, kitchen equipment, elevators, etc) are entered into the model
in the "Equipment" tab of internal loads. For the LEED form, I need to
separate these process end uses. I see no way of assigning each internal
load to a submeter. Do I now have to start over and model these process
loads as direct loads on separate sub-meters?
Thanks for any replies,
Omer Moltay, LEED AP
Equest-users mailing list
To unsubscribe from this mailing list send a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Equest-users