[Equest-users] Heated Plenum

[Carol Gardner]

Just a little addition to Jeremy's response, set the plenum space to
conditioned also. Then you will have no inconsistencies.

Carol

On Sun, Oct 17, 2010 at 9:25 AM, Jeremy McClanathan <
jmcclanathan at cdiengineers.com> wrote:

>   I forgot to mention that you need to be in the detailed edit mode to do
> this.  In the wizard, set the flr-flr height 4’ higher than the flr-clg
> height and it will automatically create your plenum for you.  Once you are
> finished in the wizard, move to the detailed edit mode.  Then, set the
> zone type to conditioned and apply a heating schedule.
>
>
>
> Also, in the wizard, if you set the HVAC system to “one per floor”, then
> the wizard will create only one plenum for each floor.
>
>
>
> Jeremy
>
>
>
> *From:* Jeremy McClanathan
> *Sent:* Sunday, October 17, 2010 9:06 AM
> *To:* 'Attiq Rahman'; 'equest-users at lists.onebuilding.org'
> *Subject:* RE: [Equest-users] Heated Plenum
>
>
>
> You can set the zone type to conditioned and apply a heating schedule.
>
>
>
> Jeremy
>
>
>
> *From:* Attiq Rahman [mailto:attiqurrahman at hotmail.com]
> *Sent:* Sunday, October 17, 2010 6:27 AM
> *To:* equest-users at lists.onebuilding.org
> *Subject:* [Equest-users] Heated Plenum
>
>
>
> Hi there,
>
>
>
> I am modeling a building in eQUEST. This building has a garage on the ground floor and the
>
> ceiling above is concrete, there is a(4' high)plenum below this concrete ceiling. This plenum is heated (with condensing furnaces)in
>
> order to heat/temper the concrete ceiling which is the floor for the residents on the 2nd floor. (I know hydronic heating could be used)
>
> Any ideas how this can be modeled in eQUEST.
>
>
>
> Thanks.
>
>
>
> Attiq
>
> This email message, including any attachments, is for the sole use of the
> intended recipient and may contain confidential, proprietary, and/or
> privileged information, as well as content subject to copyright and other
> intellectual laws.  If you are not the intended recipient, you may not
> disclose, use, copy, or distribute the email message or its attachments.  If
> you believe you have received this email message in error, please contact
> the sender by reply email, immediately delete this email and destroy copies.
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>


-- 
Carol Gardner PE
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20101018/88e3fc99/attachment-0002.htm>