[Equest-users] VAV with Electric Reheat

[Will Mak]

You have to put a value for the reheat delta T or the reheat coils don't kick on.

 

William Mak, LEED AP BD+C
Mechanical Design Engineer

EPSTEIN
Architecture
Interiors
Engineering
Construction

Sustainability

600 West Fulton Street
Chicago, Illinois 60661-1259

D: (312) 429-8116
F: (312) 429-8800

E: wmak at epsteinglobal.com <mailto:wmak at epsteinglobal.com> 
W: www.epsteinglobal.com <http://www.epsteinglobal.com/> 

þ Epstein is a firm believer in sustainability. We ask that you please consider the environment before printing this e-mail.

 

From: equest-users-bounces at lists.onebuilding.org [mailto:equest-users-bounces at lists.onebuilding.org] On Behalf Of DongEun Kim
Sent: Thursday, June 23, 2011 11:58 PM
To: equest-users at lists.onebuilding.org
Subject: [Equest-users] VAV with Electric Reheat

 

Hi all,

 

Can anyone give me an advice regarding a problem described below?

 

I need to model a VAV system with chilled water coil and hot water coil, and also with Electric Reheating.

 

As a start,  I selected  'VAV with HW Reheat' system.

 

However, I've realized that the system only generates a reheating coil without a main hot water coil(heating coil).

 

So I installed  'heating coil'  in the detailed mode, and then, I  changed the zone heat source to be 'electric'.

 

 

However when I take a look at the result, there came two problems.

 

1. Heating was mainly done by reheating coil not by main heating coil.

 

2. Reheating didn't seem to use electricity.

 

Any advice will be greatly appreciated.

 

Thank you in advance.

 

~DE 

 

Kim, DongEun(DE) | Research Engineer, LEED AP
Annex R&D Institute, HIMEC(Hanil Mech. & Elec. Consultants)

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20110624/9358b0f7/attachment-0002.htm>