[Equest-users] (no subject)

[R B]

When you are drawing the zones, make sure your exterior wall coordinates
line up with the footprint lines - any zone line that matches with the
footprint line is an exterior wall. I always double check the vertices to
make sure that is the case.
-Rohini

On Wed, May 4, 2011 at 3:21 PM, Brad Robinson <brad.robinson at yahoo.com>wrote:

> I have looked through the email archive and found a number of examples on
> how to convert an exterior wall into an interior, but I seem to have the
> opposite problem -  I need to make an internal wall exterior.  I have run
> across this a few times when testing eQuest.  I inexplicably end up with one
> exterior wall showing up as interior in my model.  In The DD wizard, I have
> tried right clicking on the wall and, but it already shows up as exterior.
> Has anyone else had this problem, or know how to force it to an exterior
> wall?  A better question is why does this happen?
>
>
>
> Thanks.
>
>
> Brad Robinson
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20110504/ebb26cd3/attachment-0002.htm>