[Equest-users] performance or pump curve

[Erik Turner]

Jamie,
After you've run your model click on the component tree a the bottom
left. Click on water side and find the pump you want to learn about in
the tree on the left (or the picture in the large "P&ID" in the middle).
Double click on it, then click on the curve tab. This will show you the
name of the curve associated with the equipment. You need to remember
the name, go back to the tree and under the "Performance Curves" folder,
find the curve and double click it. There you can find information about
the curve in question.
 
Note that to edit the curve (vs just look at it) you need to be in
detailed data edit mode. Might be worth reading up a bit in the
documentation about the two modes and when you want to switch between.
Once you switch from data back to the wizard, you'll lose the detailed
data you've entered...
 
hope that helps,
 
 
Erik Turner EIT, LEED AP+BD+C
 
Mechanical Engineer
Robison Engineering
P: (206) 364-3343
F: (206) 364-3363
www.robisonengineering.com <http://www.robisonengineering.com/> 

________________________________

From: equest-users-bounces at lists.onebuilding.org
[mailto:equest-users-bounces at lists.onebuilding.org] On Behalf Of jaime
perpinan
Sent: Friday, May 06, 2011 3:40 PM
To: equest-users at lists.onebuilding.org
Subject: [Equest-users] performance or pump curve


Hello

Im a newby to eQuest and email list trying to find out about performance
and pump curves. Im currently run simulation on a H2o screw pump and
trying to figure out how to view the performance curves. Any information
is welcome

Thank you

J

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20110509/8a253504/attachment-0002.htm>