[Equest-users] New Model Invalid Error

[R B]

You should change the compatibility mode on equest. Right click on the
program icon and you will get a properties window. Under compatibility tab,
you can set it to windows XP. The error will go away.
Note that I have not been able to get the economizer to work the regular
way in this mode. I have to use the min air schedule of 0.001 to get the
economizer to work.
-Rohini

On Thu, Mar 8, 2012 at 4:18 PM, Garrett Elder <glelder89 at gmail.com> wrote:

> Hi All,
>
> I have created a new model and stacked shells on top of one another to
> create a 13 story building. I have no warnings or errors when I finish as I
> leave the wizards. When I re-enter the wizards and change my roof, wall, or
> floor constructions I get an invalid arguement, but I can close and re-open
> with no problems. I know this usually means there is a small error that the
> program is not actually picking up, but I do not know where to start
> looking for this problem. Or could I just ignore this invalid arguement
> because I can still run the simulation and get results. I've read in the
> archives about this topic and they are helpful in explain it could be the
> roof because my shells are stacked. Could I fix this by unstacking my
> shells and have them beside eachother all in the model and defining them
> individually, would this give the same results since the same area would be
> difined and my exporsures would be defined either as exposed or adibatic.
> That idea may be a little far out there but at this point I'm willing to
> try just about anything to fix this.
>
> Thanks
> Garrett
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20120309/a6c26607/attachment-0002.htm>