[Equest-users] DD Wizard error

[Colin Bates]

I had just finished setting up my project through the Design Development Wizard and when I hit "Finish" I get an error reading "An invalid Argument was encountered".  After this happens, I cannot get back to my data in the wizard.  If I close without saving, the project file reloads just fine, but errors whenever I select "Finish"  I can even run a simulation when I first open the file before reentering the wizard.

Has anyone encountered a similar error and/or know of a fix?  I've even tried reinstalling equest.

Colin Bates, PE
Mechanical Engineer
Meier Architecture*Engineering

[cid:image001.jpg at 01CD3F4A.490D9890]

509-735-1589 Main
509-737-6962 Office
509-783-5075 Fax

ü Please consider the environment before printing this email.
PLEASE NOTE:  This message, including any attachments, may include privileged, confidential and/or inside information.  Any distribution or use of this communication by anyone other than the intended recipient is strictly prohibited and may be unlawful.  If you are not the intended recipient, please notify the sender by replying to this message and then delete it from your system.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20120531/8edbf036/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.jpg
Type: image/jpeg
Size: 3382 bytes
Desc: image001.jpg
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20120531/8edbf036/attachment.jpg>