[Equest-users] Louvers on Solid Surface

[Jeff Haberl]

Omar.

Shades on well-insulated

Jeff S. Haberl, Ph.D., P.E., FASHRAE, FIBPSA
Department of Architecture
Texas A&M University
College Station, Texas 77845-3581
Office: 979-845-6507, Lab: 979-845-6065
Fax: 970-862-2457, jhaberl at tamu.edu<mailto:jhaberl at tamu.edu>, www.esl.tamu.edu<http://www.esl.tamu.edu>

On Dec 25, 2013, at 2:56 AM, "Omar Osama" <o_osama at live.com<mailto:o_osama at live.com>> wrote:

Dear all,
            I need to know the best way to model aluminum louvers that is placed on an exterior brick wall on a southern elevation. Should I create exterior walls that resembles the louvers for each zone,, or assume a very low U-value for this wall, or there is an appropriate way that the software allow for this case?
Any help would be highly appreciable,

Regards,
Omar ElRawy
Project Engineer,
EA Sustainable Building Consultants
www.ea-buildingconsultants.com<http://www.ea-buildingconsultants.com/>
________________________________
_______________________________________________
Equest-users mailing list
http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
To unsubscribe from this mailing list send  a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG<mailto:EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20131226/fe89e2be/attachment-0002.htm>