[Equest-users] Error: Hot Water Loop has zero design flow

[Arpan Bakshi]

Mike, it's possible you forgot to model a pump, or accidentally deleted it
on your water-side.



*Arpan Bakshi**    *LEED AP BD+C, ESTIDAMA PQP


On Mon, Feb 4, 2013 at 5:49 PM, Mike Raiva
<mraiva at williamsengineering.com>wrote:

> Hello,****
>
> ** **
>
> I have been scratching my head trying to located the following simulation
> error:****
>
> ** **
>
> “Loop: Hot Water Loop                   has zero design flow.****
>
>              Check input for consistency, or specify design loads.
> ****
>
> “****
>
> ** **
>
> I have gone into my HW plant and entered my loop head and flow. See below.
> However, the error won’t go away.****
>
> ** **
>
> ****
>
> ** **
>
> *MICHAEL RAIVA, **P.Eng., LEED® AP*****
>
> *Mechanical*
>
> ** **
>
> *Williams Engineering Canada Inc.*
>
> *T:*  778.484.2983    *F:*  778.484.3901****
>
> *W:*  williamsengineering.com <http://www.williamsengineering.com>****
>
> * *
>
> *Engage.  Innovate.  Inspire.*
>
> * *
>
> *Please consider the environment before printing this email.*
>
> *Email Transmission Policy* <http://www.williamsengineering.com/legal>****
>
> ** **
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130207/be22429c/attachment-0002.htm>