[Equest-users] zone assignments

[John Aulbach]

Hi Ginny:

It would help to see you .PD2 file and .INP file to see what is not being triggered ON. Do you have a fan schedule? BTW, you CAN look at the Detail stuff in the SD or DD Wizard mode, just by going to the low left area and clicking om the right tab (component tree vs actions) to see what schedules are showing. Sounds like the fans aren't coming on.

John Aulbach




________________________________
 From: Ginnie Schofield <GSchofield at edaengineering.com>
To: "equest-users at lists.onebuilding.org" <equest-users at lists.onebuilding.org> 
Sent: Monday, February 25, 2013 6:37 AM
Subject: [Equest-users] zone assignments
 

 
Very new to Equest.  Did simulation run, no heating or cooling load (MBH) results.  Doesn’t appear zones are assigned to system (only one system for simplicity).  I get cfm requirements, utility $, but no MBH on system or zone summaries. Input under schematic wizard, converted to DD wizard, not yet converted to detail edit.
 
 
 
GINNIE SCHOFIELD
ENGINEERING DESIGN ASSOCIATES
1607 CY Ave, Ste 303, Casper, WY 82604
(Ph) 307-266-5033   (Fx) 307-234-3805
 
 
 
_______________________________________________
Equest-users mailing list
http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
To unsubscribe from this mailing list send  a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130225/9ee10573/attachment-0002.htm>