[Equest-users] eQuest - Windows 8 Compatibility

[Jeremy Poling]

Thanks - I was hoping that part of Windows didn't change much from Windows
7 and it sounds like the same steps should work.

I appreciate the insight!
Jeremy R. Poling, PE, LEED AP+BDC




On Wed, Jan 23, 2013 at 3:21 PM, Dave Weigel - The Watt Doctors LLC <
dave.weigel at thewattdoctors.com> wrote:

>   Hi Jeremy,
>
> Windows 8 no problem.  I strongly advise for best stability that you set
> compatibility mode to XP Service Pack 3 and check the Run as Administrator
> box while you’re in the compatibility dialog box.  Doing so almost
> completely eliminated the once-in-a-while eQuest freeze-up when working a
> large model. Same advice goes for Windows 7.
>
> Dave
>
>  *From:* Jeremy Poling <jeremy.poling at att.net>
> *Sent:* Wednesday, January 23, 2013 1:45 PM
> *To:* equest-users at lists.onebuilding.org
> *Subject:* [Equest-users] eQuest - Windows 8 Compatibility
>
>  Working through getting a new modeler setup to use eQuest and it dawned
> on me that I had not yet tried a Windows 8 install and can't remember
> seeing anything on the list about that either.  Any known issues with
> installing eQuest 3.64 in a Windows 8 environment?
>
> And please...for my inbox's sake...I'd rather not hear about the pros/cons
> of various operating systems...just the facts on if the two can play
> together :)
>
> Thanks much!
>  Jeremy R. Poling, PE, LEED AP+BDC
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130123/46863a53/attachment-0002.htm>