[Equest-users] low heating requirements

[Kent Beason]

I'm looking to wrap up the baseline of the attached where I'm modeling two
100% outside air systems (ApG #3).  The low heating requirements that are
reported do not seem reasonable given the 100% outdoor air w/o heat recovery
(for baseline).  I've looked through the archives for modeling DOAS so I
apologize as I'm sure that my question is redundant.  I've set the minimum
outside air ratio to 1.0 which didn't change the results from when it was
the default (blank).  I've attached my pd2 and inp files.  Is my outside air
set correctly?

 

Kent Beason

Estes, McClure & Associates, Inc.

3608 West Way

Tyler, TX 75703

-------------------------

office - 903 581 2721

cell - 830 609 8904

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130617/02f5262d/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Kennel BaselineTest.pd2
Type: application/octet-stream
Size: 16827 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130617/02f5262d/attachment.obj>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Kennel BaselineTest - Baseline Design.inp
Type: application/octet-stream
Size: 61784 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130617/02f5262d/attachment-0001.obj>