[TRNSYS-users] range check error

[mcdowell at tess-inc.com]

Raffaele -

A range check error is a generic FORTRAN error and can be hard to 
diagnose. But I suspect that your error is caused by trying to set an 
exterior surface to have an internally calculated convective 
coefficient.  Exterior surface convection coefficients must be user 
defined or inputs.

Regards,

Tim

---
Timothy P. McDowell
Executive Vice President
Thermal Energy System Specialists, LLC
22 N Carroll St, Suite 370
Madison, WI 53703
608-274-2577

On 2013-03-18 06:09, raffaelecazzato at libero.it wrote:
> Good morning,
>
> when I select in the wall type, internal calculation for the 
> convective
> coefficient,
>
> the simulation will start only if I select one of two options front 
> or back,
>
> if I select both, the simulation does not start and exit the 
> following error
> message:
> range check error.
>
> I would know someone help.
>
> Reagards,
>
> Raffaele
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users