[TRNSYS-users] TRNSYS3D plugin & SketchUp 8: surface recognition problem

Stefano Lazzari stefano.lazzari at unibo.it
Tue Sep 17 02:24:04 PDT 2013


Dear Forum,

I am a new user of TRNSYS 17 and SketchUp 8. After creating the geometry
within SketchUp (paying attention to draw always "inside" each activated
zone) I saved both .skp and .idf files without getting error messages. Then,
I opened the .skp file in SkethUp to proceed with the matching of adjacent
surfaces. However, when I activate a zone some (many) surfaces are not
recognized by the Object Info Tool (they can be selected on screen but are
simply not seen by the Object Info Tool: the area showing Object Inputs
properties is blank and the gray text "No EnergyPlus object selected"
appears). Where I am wrong? Since the geometry is quite complicated, I hope
I do not need to rebuild it from scratch.

Thank you very much for your help.

Regards,

 

Stefano Lazzari   

 

 

 

 

 

 

Dr. Eng. Ph.D. Stefano Lazzari
Department of Industrial Engineering (DIN)
School of Engineering and Architecture, University of Bologna
Viale del Risorgimento 2, I-40136 Bologna, Italy
Tel. [+39] 051 2093383     Fax [+39] 051 2093296
Homepage: http://www.unibo.it/docenti/stefano.lazzari
E-mail: stefano.lazzari at unibo.it

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130917/86610520/attachment-0001.htm>


More information about the TRNSYS-users mailing list