[TRNSYS-users] TRNSYS3D plugin & SketchUp 8: surface recognition problem

Muhammad Tauha Ali mali at masdar.ac.ae
Tue Sep 17 02:44:44 PDT 2013


You probably need to open .idf file in sketchup instead of .skp file.

Thanks,
Tauha

From: trnsys-users-bounces at cae.wisc.edu [mailto:trnsys-users-bounces at cae.wisc.edu] On Behalf Of Stefano Lazzari
Sent: Tuesday, September 17, 2013 1:24 PM
To: trnsys-users at cae.wisc.edu
Subject: [TRNSYS-users] TRNSYS3D plugin & SketchUp 8: surface recognition problem

Dear Forum,
I am a new user of TRNSYS 17 and SketchUp 8. After creating the geometry within SketchUp (paying attention to draw always "inside" each activated zone) I saved both .skp and .idf files without getting error messages. Then, I opened the .skp file in SkethUp to proceed with the matching of adjacent surfaces. However, when I activate a zone some (many) surfaces are not recognized by the Object Info Tool (they can be selected on screen but are simply not seen by the Object Info Tool: the area showing Object Inputs properties is blank and the gray text "No EnergyPlus object selected" appears). Where I am wrong? Since the geometry is quite complicated, I hope I do not need to rebuild it from scratch...
Thank you very much for your help.
Regards,

Stefano Lazzari






Dr. Eng. Ph.D. Stefano Lazzari
Department of Industrial Engineering (DIN)
School of Engineering and Architecture, University of Bologna
Viale del Risorgimento 2, I-40136 Bologna, Italy
Tel. [+39] 051 2093383     Fax [+39] 051 2093296
Homepage: http://www.unibo.it/docenti/stefano.lazzari
E-mail: stefano.lazzari at unibo.it<mailto:stefano.lazzari at unibo.it>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130917/a4543513/attachment-0001.htm>


More information about the TRNSYS-users mailing list