[TRNSYS-users] IF statemenet

metkell yebiyo metkell at yahoo.com
Thu Feb 13 05:19:08 PST 2014


Dear TRNSYS users,

Could you anyone tell me if it is possible to write an if statement in the equation box,
I am trying to send a control signal based on the outside temperature, if outside air temperature is
greater than 18 deg C then the heat pump would run in cooling mode else if the outside air temperature is less than 14 deg C then  the heat pump would run in heating mode.

Any suggestions would be appreciated thank you very much.


Regards,
Metkel

Metkel Yebiyo BEng (Hons), MSc
CEREB PhD Researcher - Ground Source Heat Pumps 
Room T615 
Department of Urban Engineering 
Faculty of Engineering, Science and the Built Environment
London South Bank University, 
103 Borough Road,
London SE1 0AA
Tel: +44 (0)20 7815 7639
E: yebiyom at lsbu.ac.uk
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20140213/5ab667dd/attachment-0001.htm>


More information about the TRNSYS-users mailing list