[TRNSYS-users] IF statemenet

[Soudabeh Neshastehriz]

Hi
There is not any "IF" statement in equation.However you can use greater
than (GT) or less than (LT) in equation box to make your conditional
statement.
Regards,
Soudabeh


On Fri, Feb 14, 2014 at 12:19 AM, metkell yebiyo <metkell at yahoo.com> wrote:

> Dear TRNSYS users,
>
> Could you anyone tell me if it is possible to write an if statement in the
> equation box,
> I am trying to send a control signal based on the outside temperature, if
> outside air temperature is
> greater than 18 deg C then the heat pump would run in cooling mode else if
> the outside air temperature is less than 14 deg C then  the heat pump
> would run in heating mode.
>
> Any suggestions would be appreciated thank you very much.
>
>
> Regards,
> Metkel
>
> Metkel Yebiyo BEng (Hons), MSc
> CEREB PhD Researcher - Ground Source Heat Pumps
> Room T615
> Department of Urban Engineering
> Faculty of Engineering, Science and the Built Environment
> London South Bank University,
> 103 Borough Road,
> London SE1 0AA
> Tel: +44 (0)20 7815 7639
> E: yebiyom at lsbu.ac.uk
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20140214/3e653b2d/attachment-0001.htm>