[TRNSYS-users] min flow rate active layer

elena.bee at libero.it elena.bee at libero.it
Mon Jul 7 05:38:43 PDT 2014


Hi everyone! 

I hope somebody can help me with this issue…
In active layer there is a minimum mass flow rate and it's not allowed to go 
under that value, so how can I simulate a variable system, where the mass flow 
is controlled by a thermostat and it varies linearly from zero (no heat is 
required) to 1 (maximum flow rate-project value). When the coefficient is near 
zero, the flow is too low and it gives error… Is there a solution?

Thanks in advance



More information about the TRNSYS-users mailing list