[Bldg-sim] eQUEST simulation

[Robert Lord]

I don't know anything about eQuest. We utilise TAS and it is successful in modelling buildings without HVAC, with full HVAC or even with "fan-only" HVAC.


Regards


Rob Lord
Lincolne Scott
1 Gardner Close
Milton Qld 4064
Ph:          61 7 3368 6614
Fax:        61 7 3368 6699
Mobile:   0418 641 707
Email:    rgl.lsbris at lincolne.com.au

This message contains information that is intended for the addressee.  If you have received this message in error, you are asked to respect its confidentiality by destroying it and not copying or disclosing it.  Please notify the sender and remove it from your computer system.  Lincolne Scott accepts no responsibility concerning the security, transmission, content, virus status or delay in receipt of any information electronically transmitted.



-----Original Message-----
From: Gllf22 at aol.com [mailto:Gllf22 at aol.com]
Sent: Friday, April 26, 2002 8:05 AM
To: Bldg-sim at gard.com
Subject: [Bldg-sim] eQUEST simulation


I would like to use eQUEST to simulate buildings that do not have any HVAC 
equipment and that will be naturally ventilated.  I am interested in getting 
hourly temperature of different locations within the buildings.  I would like 
to get some advice and guidance on how to do this?  Thanks in advance for any 
suggestions.

-Gladys Lopez



======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM


===========================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM