[bldg-sim] eQUEST
Vikram Sami
VSami at lasarchitect.com
Mon Dec 27 10:34:39 PST 2004
Mohit,
You should model the surface only once. Typically, (in the eQUEST default models), its done with the roof (or ceiling) of the lower floor representing the surface. When you build the surface, you will be asked to define adjacencies (what space is next to it) for itnernal surfaces. If you are modelling a surface that has an external exposure, you might need to break it up into 2 surfaces though - one for the internal surfaces, and one for external surfaces. Also, if there is one room adjecent to 2 rooms, (say you have 2 spaces on the top floor, and one on the bottom), it would probably make more sense to model it as 2 floors or 2 ceilings, because you can define only one adjacency per internal surface.
hope that helps
Vikram
Vikram Sami, LEED AP
Direct Phone 404-253-1466 | Direct Fax 404-253-1366
LORD, AECK & SARGENT ARCHITECTURE
Responsive Design * Technological Expertise * Exceptional Service
www.lordaecksargent.com
-----Original Message-----
From: postman at gard.com [ <mailto:postman at gard.com> mailto:postman at gard.com]On Behalf Of Mohit Mehta
Sent: Monday, December 27, 2004 12:08 PM
To: bldg-sim at gard.com
Subject: [bldg-sim] eQUEST
Hi,
I have two spaces (with almost similar profiles) one on top of the
other; the upper space has a "floor" and the lower (say interstitial)
space has a "roof" (basically an internal floor for the most part but it
does get exposed at some places). How does eQUEST read the constructions
or R-values? Does it take one or both constructions or does it add the
R-values where they do overlap?
Thank you,
~m
==================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20041227/a973fcfc/attachment-0002.htm>
More information about the Bldg-sim
mailing list