[BLDG-SIM] Heat recovery in eQUEST (yes - another question)
Jeff Haberl
jeffhaberl at tees.tamus.edu
Wed Jun 1 06:12:00 PDT 2005
Depends on the system and building loads.
What's the system? What are the internal loads?
Jeff
8=! 8=) :=) 8=) ;=) 8=) 8=( 8=) 8=() 8=) 8=| 8=) :=') 8=)
8=) 8=?
Jeff S. Haberl, Ph.D.,
P.E.............................jhaberl at esl.tamu.edu
Professor......................................................Office
Ph: 979-845-6507
Department of Architecture.......................Lab Ph: 979-845-6065
Energy Systems Laboratory.......................FAX: 979-862-2457
Texas A&M University..............................77843-3581
College Station, Texas, USA.......................URL: www-esl.tamu.edu
8=/ 8=) :=) 8=) ;=) 8=) 8=() 8=) :=) 8=) 8=! 8=) 8=? 8=)
8=) 8=0
________________________________
From: postman at gard.com [mailto:postman at gard.com] On Behalf Of Vikram
Sami
Sent: Tuesday, May 31, 2005 5:43 PM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] Heat recovery in eQUEST (yes - another question)
I followed the method suggested earlier to model the heat recovery
system (Renee's email). I set the ERV type to 'enthalpy wheel', with the
make up air temp ctrl set to mixed air reset & capacity control to '
trim economizer's (the design engineer suggested this was the closest to
the designed system).
The overall savings shown were minute, with a penalty shown on the
electric side in fans (this I had foreseen from additional static
pressure needed to drive the air through the enthalpy wheel) & space
cooling (this was surprising - especially since the base system had
humidity controlled at 50%). The space heating was the only thing which
showed considerable savings.
Am I missing something, or does this mean that the system (a Semco ERV
unit) is probably not great for this climate (Asheville, NC).
I would appreciate any insight into this
Thanks
Vikram Sami, LEED AP
Direct Phone 404-253-1466 | Direct Fax 404-253-1366
LORD, AECK & SARGENT ARCHITECTURE
Responsive Design * Technological Expertise * Exceptional Service
www.lordaecksargent.com
==================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20050601/86f096f7/attachment.htm>
More information about the Bldg-sim
mailing list