[BLDG-SIM] Negative net wall area
Steve Mignogna
smignogna at gmail.com
Fri May 18 07:42:34 PDT 2007
Kevin,
Make sure that the (window width + 2x the frame width) is less then
the wall width. The same goes for the height. If the whole building
is covered in glazing, make sure you do this for each wall.
Steve
On 5/11/07, Kevin J. Kyte <kkyte at robsonwoese.com> wrote:
> I am encountering a problem where the glazing system I need to use covers
> the entire wall area resulting in a negative net wall area and bad building
> components. Does anyone have any solutions that get around this problem? A
> related question to this would be, what is the best way to model spangrel
> glass?
> The spangrel is to be used throughout also. Thank you for any advice.
>
>
>
>
> Kevin
>
>
>
>
> ======================================================
> You received this e-mail because you are subscribed
> to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
> from this mailing list send a blank message to
> BLDG-SIM-UNSUBSCRIBE at GARD.COM
>
>
--
Steve Mignogna
Atelier Ten
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list