[BLDG-SIM] Laboratory systems to comply with T-24 and 90.1

[Peter Simmonds]

OK, these questions may seem fundamental for some people and if they are
then I should get the answers and clarification I am looking for:

1.	It used to be a common thought that laboratory systems were
process systems and therefore exempt from anyT-24 compliance and for
that matter 90.1, this doesn't seem to be the case as T-24 classes
Laboratories under the CBC definition as occupancy B and therefore must
comply. But what about the process loads, there doesn't seem to be any
clear direction here, so we include them when the don't affect the
results and leave them out when the affect the results (who says
Engineers don't think outside of the box).
2.	90.1, or at least the parts I read does not clearly state how
laboratory systems and process loads are to be simulated.

 

Please help guide a poor engineer through melee of confusion, thanks

 

Peter Simmonds Ph.D.

Associate
IBE Consulting Engineers

14130 Riverside Drive Suite 201

Sherman Oaks, CA 91423
p:   (818) 377-8220
f:    (818) 377-8230
m:  (818) 219-1284
IDEAS FOR THE BUILT ENVIRONMENT <BLOCKED::http://www.ibece.com/> 

This e-mail message, including any attachments, is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. Any unauthorized review, use, disclosure, or distribution
is prohibited. If you are not the intended recipient, please contact the
sender by reply e-mail and destroy all copies of the original message.

 



===========================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20071129/e51b0db4/attachment.htm>