[BLDG-SIM] eQuest atrium modelling
Justin Wong
justinw at fbe.unsw.edu.au
Mon Nov 5 14:42:21 PST 2007
John,
The space adjacent to these wall has the correct volume? space
definition is area polygon times a constant height right?
Correct me if I am wrong here.
Justin
Aulbach, John wrote:
> Justin:
>
> Is this an atrium that has outside walls as part of its construction?
> You can ALWAYS tilts surfaces in +- vertical directions, with 0Deg =
> face down, 90 Deg = vertical wall, and 180 Deg being a roof. So tilt
> your walls and make your roof larger than your floor. And any windows in
> those walls should have the same tilt as the walls automatically.
>
> I see no reason why this won't work.
>
> -----Original Message-----
> From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of Justin
> Wong
> Sent: Sunday, November 04, 2007 1:42 PM
> To: BLDG-SIM at gard.com
> Subject: [BLDG-SIM] eQuest atrium modelling
>
> Hi all,
>
> I am looking for a way to model an atrium that has a wider base than the
> top. Is there a way to specify tilted wall in eQuest?
>
> Thanks and regards,
>
> Justin Wong
>
>
>
> ======================================================
> You received this e-mail because you are subscribed to the
> BLDG-SIM at GARD.COM mailing list. To unsubscribe from this mailing list
> send a blank message to BLDG-SIM-UNSUBSCRIBE at GARD.COM
>
>
>
>
--
Justin Wong
PhD Candidate
Faculty of the Built Environment
University of New South Wales
UNSW SYDNEY, NSW 2052 Australia
Room 6007, West Wing, Red Centre
(T)+61 2 9385 6373 - (M)+61 424 036 249
justinw at fbe.unsw.edu.au
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list