[Bldg-sim] VisualDOE unmet load hours

Rob Salcido RSalcido at archenergy.com
Tue Aug 25 12:32:16 PDT 2009


Hello Christopher,
 
Look in the SS-F or SS-R reports for each zone in the output/simulation
file and that will show the hours the heating or cooling loads are
underserved.
 
Rob Salcido
 
 


>>> "Christopher Zabaneh" <christopher.zabaneh at ibece.net> 8/25/2009
11:52 AM >>>

I’m trying to find the unmet load hours for the purposes of a LEED EAc1
template.
 
I can get them on a room-by-room basis from the Simulation > Diagnostic
tab – is there a summary of the total heating and cooling in the reports
we can point to for documentation purposes?
 
Thanks kindly,
 
Christopher F. Zabaneh
Engineer, LEED® AP
IBE Consulting Engineers
14130 Riverside Drive, Suite 201
Sherman Oaks, CA 91423‑2313
p    (818) 377‑8220  X 295
f     (818) 377‑8230
IDEAS FOR THE BUILT ENVIRONMENT ( http://www.ibece.com/ )
 
“The effective date for the 2008 Building Energy Efficiency Standards
has been changed from August 1, 2009 to January 1,
2010.”http://www.energy.ca.gov/title24/2008standards/notices/2009-06-29_notice_effective_date.html

This e-mail message, including any attachments, is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. Any unauthorized review, use, disclosure, or distribution
is prohibited. If you are not the intended recipient, please contact the
sender by reply e-mail and destroy all copies of the original message.
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20090825/090f4709/attachment-0002.htm>


More information about the Bldg-sim mailing list