[Bldg-sim] DOE, PNNL Release Report on Cutting Energy Use in Half in Quick Service Restaurant

Leach, Matt Matt.Leach at nrel.gov
Tue Oct 12 11:37:29 PDT 2010


NREL also released two 50% TSDs for commercial buildings.  See press release excerpts below from EERE News:
DOE, NREL Release Reports on Cutting Energy Use in Half in Commercial Buildings
September 24, 2010

Reports detail strategies to save energy in large office buildings and large hospitals

The U.S. Department of Energy and its National Renewable Energy Laboratory (NREL) have released two technical reports that provide recommendations on how to achieve 50% energy savings in large office buildings and large hospitals. Conducted by NREL's Commercial Buildings Group, under the direction of DOE's Building Technologies Program, the studies support DOE's goal of significantly improving the energy efficiency of new and existing commercial buildings across the United States.

Technical Support Document: Strategies for 50% Energy Savings in Large Office Buildings[cid:image001.gif at 01CB6A0A.088740D0]<http://www.nrel.gov/docs/fy10osti/49213.pdf> evaluates the potential for new large office buildings to achieve a 50% net onsite energy savings compared to a baseline standard (as defined by ANSI/ASHRAE/IESNA Standard 90.1-2004). The report found 50% energy savings can be achieved in both low-rise and high-rise office buildings in a broad range of U.S. climates. The analysis was conducted in 16 cities that represented different climate zones, such as hot and humid, hot and dry, marine, cold and humid, and cold and dry. The following energy-efficiency measures helped researchers reach the 50% energy-savings target:
*         Lighting power density was reduced in office spaces and occupancy sensors were used in infrequently occupied spaces.
*         High-efficiency boilers, chillers, air distribution units, and service water heating equipment were installed.
*         Plug loads were reduced by purchasing high-efficiency electronic equipment and using special controls that shut off equipment when not in use.

Large Hospital 50% Energy Savings: Technical Support Document[cid:image001.gif at 01CB6A0A.088740D0]<http://www.nrel.gov/docs/fy10osti/47867.pdf> details the technical analysis performed and the resulting design guidance that will enable large hospitals to achieve whole-building energy savings of at least 50% over the above standard. The large hospitals report also documents the modeling methods used to demonstrate how the design recommendations will help institutions meet or exceed the 50% energy-savings goal. This report found 50% energy savings can be achieved in large hospitals across all eight U.S. climate zones. Energy savings range from 50.6% to 61.3%, with the smallest savings in humid climates and extremely cold climates. The highest energy savings were achieved in marine climates, with relatively high energy savings achieved in dry climates. In general, for each climate type (humid, marine, and arid), savings were seen to decrease as the climate became progressively colder.

DOE commissions these types of technical reports, called technical support documents (TSDs), to describe the assumptions, methodologies, and analyses used to achieve certain levels of energy performance.  In many cases, technical support documents are the basis for Advanced Energy Design Guides (AEDGs), which are "how-to" guides that show architects, engineers, and building designers how to achieve above-code exemplary energy performance for buildings using existing technologies available today. The American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE) works in collaboration with DOE, the American Institute of Architects, the Illuminating Engineering Society of North America, and the U.S. Green Building Council to develop and publish AEDGs.

In addition to the ASHRAE design guides, the results of these studies will be shared with DOE's Commercial Building Energy Alliances. These alliances are public-private collaborations aimed at developing energy-efficient technologies and practices and sharing the information with commercial building owners and operators around the United States.


From: bldg-sim-bounces at lists.onebuilding.org [mailto:bldg-sim-bounces at lists.onebuilding.org] On Behalf Of Liu, Bing
Sent: Monday, October 11, 2010 1:55 PM
To: bldg-sim at lists.onebuilding.org
Subject: [Bldg-sim] DOE, PNNL Release Report on Cutting Energy Use in Half in Quick Service Restaurant

DOE, PNNL Release Report on Cutting Energy Use in Half in Commercial Buildings
October 08, 2010
Report details strategies to save energy in quick-service restaurants
The U.S. Department of Energy and its Pacific Northwest National Laboratory (PNNL) have released a technical report that provides recommendations on how to achieve up to 50% energy savings in quick-service restaurants. PNNL, with help from industry collaborators and under the direction of DOE's Building Technologies Program, performed the research, analysis, and documentation that support DOE's goal of significantly improving the energy efficiency of new and existing commercial buildings across the United States.
Technical Support Document: 50% Energy Savings for Quick-Service Restaurants[cid:image001.gif at 01CB6A0A.088740D0]<http://www.pnl.gov/main/publications/external/technical_reports/PNNL-19809.pdf> details a package of energy-efficiency measures that cut energy use in quick-service restaurants by up to 50% compared to a baseline standard in less than five years. The 50% goal involves reducing site energy usage in all eight U.S. climate zones, relative to buildings constructed to meet minimal code-compliant requirements of ANSI/ASHRAE/IESNA Standard 90.1-2004.
For the analysis, PNNL developed a 2,500-square-foot building model that was based on actual floor plans in prototypical quick-service restaurant design. PNNL used EnergyPlus, an energy simulation program, to determine the energy savings provided by the energy-efficiency measures. The prototype building was analyzed in the eight U.S. climate zones, which were further divided into 16 representative climate cities. The report establishes the baseline energy use by end-use category in a typical quick-service restaurant and provides the site energy and energy cost savings from implementation of the recommended measures. The report also provides an estimate of the incremental first costs and simple payback years for an energy-efficient quick-service restaurant in various climate locations.
The following energy-efficiency measures helped researchers reach the energy-savings target:

 *   Ultra-efficient cooking appliances resulted in reduced kitchen exhaust air flow
 *   An optimized HVAC system configuration was used to better utilize a dedicated outdoor air system and runaround coil loop heat recovery
 *   Efficient exterior and interior lighting were used around the building and dimming controls were used in the dining room
 *   Enhanced insulation, cool roofs, and high-performance window glazing improved the building envelope.
The 50% savings report will provide the basis for the next series of Advanced Energy Design Guides (AEDGs), which are "how-to" guides that show architects, engineers, and building designers how to achieve above-code exemplary energy performance for buildings using existing technologies available today. The American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE) works in collaboration with DOE, the American Institute of Architects, the Illuminating Engineering Society, and the U.S. Green Building Council to develop and publish AEDGs. These are available for free public download<http://www.ashrae.org/technology/page/938>.
In addition to the ASHRAE design guides, the results of these studies will be shared with DOE's Commercial Building Energy Alliances and the Commercial Building Partnerships. These groups are public-private collaborations aimed at developing energy-efficient technologies and practices and sharing the information with commercial building owners and operators around the United States.
DOE, with its national laboratories, commissions these technical support documents (TSDs), to describe the assumptions, methodologies, and analyses used to achieve certain levels of energy performance. DOE has published documents in several categories for commercial buildings. To view previous TSDs, search the publications database<http://nrelpubs.nrel.gov/Webtop/ws/nich/www/public/SearchForm>.
The mission of the Building Technologies Program (BTP) is to develop technologies, techniques, and tools for making buildings more energy efficient, productive, and affordable. BTP focuses on improving commercial and residential building components, energy modeling tools, building energy codes, and appliance standards. For more information, visit the Building Technologies Program Web site<http://www.eere.energy.gov/buildings/>.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20101012/4e2b047f/attachment-0002.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.gif
Type: image/gif
Size: 571 bytes
Desc: image001.gif
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20101012/4e2b047f/attachment-0002.gif>


More information about the Bldg-sim mailing list