I was learning the TermReheatOA.idf.
but when I tried to autosize the 'Primary air design volumetric flow
rate' in the "AIR PRIMARY LOOP" object, 'Maximum air flow rate' and
'Max Reheat Water Flow' in "SINGLE:DUCT:CONST VOLUME:REHEAT" object,
E+ always shows the message as follows:
EnergyPlus did not complete successfully. No eplusout.end file created.
So, I even can't get the .err file.
Linda
EnergyPlus WebSite:
http://www.energyplus.gov
Owner: EnergyPlus_Support list
Member: EnergyPlus Development Team
To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.