[EnergyPlus_Support] problem

[idoebber <idoebber@xxxxxx>]

I have the following design flow rate and coefficient values for infiltration 
of a zone labeled living zone.

  Infiltration,
  	Living Zone,
  	Infiltrate Schedule,
  	0.05395,
  	0.6120,
  	0.0204,
  	0.0529,
  	0;


When I specify any design air flow rate equal or over 0.05, the system crashes 
saying

   ** Severe  ** COIL:DX:CoolingBypassFactorEmpirical" HEAT PUMP ACDXCOIL 1":
   **   ~~~   ** The given air volume flow, total capacity and sensible heat 
ratio
   **   ~~~   ** yield coil exiting air conditions above the psychrometric 
curve.
   **  Fatal  ** Check and revise the given coil input data before rerunning 
the simulation.

My HVAC system is all autosized. Is the load put on the HVAC system from a too 
large infiltration rate making the system not work.

Thanks
Ian


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Upgrade to 128-Bit SSL Security!
http://us.click.yahoo.com/p7cEmB/s7qGAA/yigFAA/dkFolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/