__._,_.___Hello
I'm a user of energy plus and I'm doing some simulation with this program.
My simulation is about WaterHeater Heat Pump (Air-to-Water Heat Pump).
In my simulation have supposed 100 % exterior air, and Radiant Low Hydronic Heating and Cooling system.
My question is for Plant-Condenser Loops part, points:
1. CondenserLoop
Can I applie this point and How ? (because is not one scheme where I can depend on it)
2. Pipe:Adiabatic:
How I can fill this point ? (because is not explaied at pdf manual)
waiting your answer
best regards
Dashamir Marini
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___
- References:
- [EnergyPlus_Support] question for: condenser and pipe adiabatic
- From: dashamir marini
- Prev by Date: Re: [EnergyPlus_Support] UtilityCost Output
- Next by Date: [EnergyPlus_Support] Re: how to change the outdoor air flow rate?
- Previous by thread: [EnergyPlus_Support] question for: condenser and pipe adiabatic
- Next by thread: [EnergyPlus_Support] How to reset the VAV box minimum air flow Fraction
- Index(es):