[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [EnergyPlus_Support] Re: is it possible to model 2 air loops
Is that node name used in the OutdoorAir:Mixer object ? If you can't
find the error you will have to upload your file so someone can take a
look at it.
Elreq wrote:
>
> This node is defined in an outisde air node list:
>
> OUTSIDE AIR INLET NODE LIST,
> AHU Outside Air Inlet; !- 1st Node name or node list name
>
> Regards,
> Santiago
> --- In EnergyPlus_Support@xxxxxxxxxxxxxxx
> <mailto:EnergyPlus_Support%40yahoogroups.com>, Richard Raustad
> <RRaustad@...> wrote:
> >
> > Did you define this node as an outdoor air node or list this node in an
> > outdoor air node list ?
> >
> > OutdoorAir:Node,
> > AHU OUTSIDE AIR INLET; !- Name
> >
> > ...or...
> >
> > OutdoorAir:NodeList,
> > OutsideAirInletNodes; !- Node or NodeList Name 1
> >
> > NodeList,
> > OutsideAirInletNodes, !- Name
> > AHU OUTSIDE AIR INLET; !- Node 1 Name
> >
> >
> > Elreq wrote:
> > >
> > > The error is:
> > > Node Connection Error, Node="AHU OUTSIDE AIR INLET", Actuator node did
> > > not find a matching node of appropriate type (other than Actuator,
> > > Sensor, OutsideAir).
> > > ** ~~~ ** Reference Object=CONTROLLER:OUTSIDE AIR, Name=AHU OA
> > > CONTROLLER.
> > >
> > > This controller is for the AHU Loop which was alreay working fine so
> > > when I added the second loop for a special zone I receive this error.
> > >
> > > Thanks.
> > >
> > > --- In EnergyPlus_Support@xxxxxxxxxxxxxxx
> <mailto:EnergyPlus_Support%40yahoogroups.com>
> > > <mailto:EnergyPlus_Support%40yahoogroups.com>, Richard Raustad
> > > <RRaustad@> wrote:
> > > >
> > > > Yes, you may use more than one air loop. Each air loop must serve
> > > > different zones. What is the strange error ?
> > > >
> > > > Elreq wrote:
> > > > >
> > > > >
> > > > > Dear Forum,
> > > > >
> > > > > I have a similar question,
> > > > >
> > > > > Is it possible to define two air loops but not for the same
> zone: one
> > > > > is for several zones and has reheat coils and the other one is
> for a
> > > > > separate zone only using direct air.
> > > > >
> > > > > I am trying to do it but receive very strange severe errors.
> > > > >
> > > > > Thanks,
> > > > > Santiago
> > > > > --- In EnergyPlus_Support@xxxxxxxxxxxxxxx
> <mailto:EnergyPlus_Support%40yahoogroups.com>
> > > <mailto:EnergyPlus_Support%40yahoogroups.com>
> > > > > <mailto:EnergyPlus_Support%40yahoogroups.com>, Fred Buhl <wfbuhl@>
> > > > > wrote:
> > > > > >
> > > > > > It is not possible. One airloop, plus as much zone equipment
> as you
> > > > > want.
> > > > > >
> > > > > > Fred Buhl
> > > > > >
> > > > > > D T wrote:
> > > > > > > Does anyone know if it possible to have 2 air loops
> servicing the
> > > > > same
> > > > > > > zone? I currently have one air loop defined for the
> largest zone
> > > > > in my
> > > > > > > facility and am trying to add another one but am trying to
> > > figure out
> > > > > > > how to connect the nodes on the demand side since that is
> where my
> > > > > > > problem lies.
> > > > > > >
> > > > > > > Thanks,
> > > > > > > Dimos
> > > > > > >
> > > > > > >
> > > > > > >
> > > > > >
> > > > >
> > > > >
> > > >
> > > > --
> > > > Richard A. Raustad
> > > > Senior Research Engineer
> > > > Florida Solar Energy Center
> > > > University of Central Florida
> > > > 1679 Clearlake Road
> > > > Cocoa, FL 32922-5703
> > > > Phone: (321) 638-1454
> > > > Fax: (321) 638-1439 or 1010
> > > > Visit our web site at: http://www.fsec.ucf.edu
> <http://www.fsec.ucf.edu>
> <http://www.fsec.ucf.edu <http://www.fsec.ucf.edu>>
> > > >
> > > > UCF - From Promise to Prominence: Celebrating 40 Years
> > > >
> > >
> > >
> >
> > --
> > Richard A. Raustad
> > Senior Research Engineer
> > Florida Solar Energy Center
> > University of Central Florida
> > 1679 Clearlake Road
> > Cocoa, FL 32922-5703
> > Phone: (321) 638-1454
> > Fax: (321) 638-1439 or 1010
> > Visit our web site at: http://www.fsec.ucf.edu <http://www.fsec.ucf.edu>
> >
> > UCF - From Promise to Prominence: Celebrating 40 Years
> >
>
>
--
Richard A. Raustad
Senior Research Engineer
Florida Solar Energy Center
University of Central Florida
1679 Clearlake Road
Cocoa, FL 32922-5703
Phone: (321) 638-1454
Fax: (321) 638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu
UCF - From Promise to Prominence: Celebrating 40 Years
------------------------------------
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/EnergyPlus_Support/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/EnergyPlus_Support/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:EnergyPlus_Support-digest@xxxxxxxxxxxxxxx
mailto:EnergyPlus_Support-fullfeatured@xxxxxxxxxxxxxxx
<*> To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/