[EnergyPlus_Support] warning shown for shading control type:MeetDaylightIlluminanceSetpoint

[surekha tetali <surekhatetali@xxxxxxxxx>]

Dear All,

I am working on EnergyPlus to model the effect of an electrochromic window.
I am inputting the required details as,
shading type:switchable glazing

shading control type:MeetDaylightIlluminanceSetpoint

There exists a field, Setpoint in this same category of WindowProperty:ShadingControl

For the input in this field, the Input/Output reference manual on Page 188 says,

"SetPoint is unused for Shading Control Type = OnIfScheduleAllows, OnIfHighGlare and DaylightIlluminance." 
So I left this field blank. Hope I understood it right.

But when i simulate this model, it's showing me a warnings as below,

** Warning ** WindowProperty:ShadingControl="FOR DAYLIGHT CONTROL, The first SetPoint is zero.

How do I solve this warning, or can I ignore it.

Thanks & Regards,


-- 
Surekha Tetali

Student, MS in Building Science
International Institute of Information Technology
Hyderabad.

__._,_.___

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___