[EnergyPlus_Support] Plant Loop Control

["Morgan" <mgbane@xxxxxxxxx>]

I'm trying to use an availability manager to control a plant loop.  I'm using both a high temperature turn on and a low temperature turn off.  Both cases look at the same node.  However, the node that is used is not in the controlled loop, it's in a different loop.  When I run a simulation w/o the manager, everything is good.  But if I implement those managers I get PlantFlowResolver warnings

x<=y<=z   this type of error...my numbers aren't matching up

I was wondering if I was creating a conflict by using a node outside the controlled PlantLoop.  I got the same error when I tried to setup a simple EMS to control the PlantLoop's respected pump.  Both setups work correctly, they perform the correct actions, but get > 30000 errors in a month's simulation.

I've seen other problems relating to PlantFlowResolver on the forum, so if anyone has experience with this and has any suggestions...

Thanks,

Morgan 

__._,_.___

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___