Re: [EnergyPlus_Support] High internal Gain Building gives surface temperatures above maximum

[Vinay Devanathan <vinay.devanathan@xxxxxxxxx>]

Hello,

I think I encountered this problem once, but I am not sure if this would work. Try to increase the convergence limits and/or time-step. 

On Tue, Jun 8, 2010 at 8:22 PM, eddiecorwin <ecorwin@xxxxxxxxxxxxxxxxxxx> wrote:

 

I am modeling a data center with a large internal gain (122 W/ft^2). But when I simulate, I get a sever error saying that a surface in the zone reaches a temperature greater than the maximum that is allowed (they get to be around 210 degreed C). Has anyone else ran into this problem? Or, has anyone modeled a building with such a high internal gain in Energy Plus before? Any help would be greatly appreciated.

-Eddie

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___