…well I got lucky…it seems that the model did not
like my concrete and R-11 insulation combination. The simulation runs
with R-13 insulation on the concrete and the only differences between the
insulations is the thickness. Apparently HAMT could not properly mesh the
R-11 thickness in combination with the concrete…
Ned
Lyon, P.E. (MA)
Staff Consultant
SIMPSON
GUMPERTZ & HEGER
781.907.9000 main
781.907.9350 direct
781.907.9009 fax
www.sgh.com
From:
EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On
Behalf Of Edward G. Lyon
Sent: Friday, July 16, 2010 7:40 AM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] HAMT Warmup is Cold
I
have a working building model that I wanted to run a HAMT simulation on.
After adding the appropriate moisture properties for the materials and slightly
altering the existing assemblies to cleanup an error, the model crashed during
warmup with an out of range low temperature on an exterior wall. Does
anyone have any suggestions for what to look for to get things running?
Ned Lyon, P.E. (MA)
Staff Consultant
SIMPSON GUMPERTZ & HEGER
| Engineering of Structures and Building
Enclosures
41 Seyon Street, Bldg. 1, Suite 500
Waltham, MA 02453
781.907.9000 main
781.907.9350 direct
781.907.9009 fax
www.sgh.com
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___