Re: [EnergyPlus_Support] Initial control over surface temperature

[Linda Lawrie <linda@xxxxxxxxxxxxxx>]

Be sure your convergence settings in the Building object are
tight enough.  It may converge before you want it to.  Also,
you can "report during warmup" so you can see where it
quits.

No, there is no way to set the initial temperatures (that are the initial
for the warmup procedure) outside the simulation.

At 05:01 AM 9/22/2010, alessandro wrote:
> Hi everybody,
>
> I'm askying if there is a way to wield control over surfaces' temperature
> at the beginning of the simulation, i.e. start the simulation with an
> imposed internal superficial temperature to structural elements of
> 18°C.  .
> Controlling the air room temperature I can bring near but it isn't
> enough.

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___