In E+, you either end up needing to use two separate chilled
water loops (and two chillers), or ignore the higher temp water for the beams
and use one supply temperature.
From:
EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On
Behalf Of jvd2pe
Sent: Thursday, September 30, 2010 7:45 AM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] Chilled Beams need a separate water
control loop
Dear Forum,
In a typical chilled water system using CHILLED BEAMS, you need:
* a chilled water loop for air handler coils at ~45F / 7C
* another chilled water loop for the chilled beams at ~60F / 15C
* both served by single chiller
Does anyone have suggestions about how to set this up in E+?
Thanks in advance!
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___