quick correction: i meant "FenestrationSurface:Detailed" for the object to be used to create the doors. hope someone can shed some light on this, i would like to model in the best possible way right from the start to avoid too much corrections later on. Thanks.
Pedro.
pedro_peixeiro wrote:
Hello all.
When modeling interior doors, is it necessary to specify the door in both adjacent surfaces relative to the two zones, or i just need to set up the door in one surface? i want to model using BuildingSurface:Detailed to make it Openstudio friendly. Also, the surfaces of each zone are on BuildingSurface:Detailed object, linked to one another through OutsideBoundaryCondition:Surface.
Pedro.
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___