Yes. The mistake was a typo in the last object.
Thanks for the help
Alan Jackson, LEED AP
KlingStubbins
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of Pedro Peixeiro
Sent: Monday, February 28, 2011 11:57 AM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: Re: [EnergyPlus_Support] Unitary control zone error
Hi Alan.
check your last unitary:unit entry. Zone name is "B_STAIR", and in your unitary:system for that zone you have "1_STAIR" as the control zone. i would guess your mistake is in the zone name for the unitary:unit object.
Pedro
On 28-02-2011 14:14, Jackson, Alan wrote:
I am getting the error below, even though I have defined the control zone for each piece of unitary equipment using the HVACTemplate objects.
** Severe ** Output:PreprocessorMessage="ExpandObjects" has the following Fatal condition:
** ~~~ ** Could not find a controlled zone for the uni
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___