[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Output-Variable for Indoor WBT



Thank you! Richard

I knew about "System Node Wetbulb Temp". I/O reference says that "The current wet-bulb temperature at a system node in degrees C.", however, I need to know the average zone inside WBT (like we get "Zone Mean Air Temperature"). I suppose "ZONE NODE:System Node Wetbulb Temp[C](Hourly)" and "ZONE OUTLET NODE:System Node Wetbulb Temp[C](Hourly)" are results at different system nodes (junctions), which I think are different from average zone inside WBT. Am I correct? 

In general terms, an output variable which gives WBT values as measured by a Sling Psychrometer in practical will help me. 

Thank you!
Vaibhav


Vaibhav Jain
Architect & Energy Analyst
Building Science Research Centre
IIIT - Hyderabad, INDIA
Mobile  +91-72076 60526


On 5 July 2011 19:20, Richard Raustad <RRaustad@xxxxxxxxxxxx> wrote:
 

You can find the output variable for your input file in the rdd file after a simulation. You can use the wild card to get all wet bulb temps for each air node or use the name of the node (e.g., zone node or any other air node).

Output:Variable,*,System Node Wetbulb Temp,hourly; !- HVAC Average [C]




On 7/2/2011 4:35 AM, Vaibhav Jain wrote:
 

Hello, 


Which output variable will give indoor wet-bulb-temperature? 

Thanks!
Vaibhav 
  
Vaibhav Jain
Architect & Energy Analyst
Building Science Research Centre
IIIT - Hyderabad, INDIA


-- 
Richard A. Raustad
Senior Research Engineer
Florida Solar Energy Center
University of Central Florida
1679 Clearlake Road
Cocoa, FL  32922-5703
Phone:   (321) 638-1454
Fax:     (321) 638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu

UCF - From Promise to Prominence: Celebrating 40 Years




__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.



Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___